archive-info.com » INFO » B » BOWDENSHOBBYCIRCUITS.INFO

Total: 50

Choose link from "Titles, links and description words view":

Or switch to "Titles and links view".
  • Voltage Divider Calculator
    be 7000 and 5000 ohms for R1 and R2 To find the series resistance needed for a 2 volt LED operating from a 12 volt battery at 20 milliamps the values 12 for the battery 02 for the current and 2 for Vout would be entered and the LED would represented by R2 The result should be 500 ohms for the series resistance R1 The calculator can also work problems

    Original URL path: http://bowdenshobbycircuits.info/r2.htm (2016-04-26)
    Open archived version from archive


  • L or C Reactance Calculator
    uF capacitor or a 25 3 mH inductor will have 159 Ohms of reactance at a frequency of 1000 Hertz Fields should be reset to 0 before doing a new calculation Inductive Reactance Xl 2 Pi F L Capacitive Reactance

    Original URL path: http://bowdenshobbycircuits.info/XLC.htm (2016-04-26)
    Open archived version from archive

  • RC Time Calculator
    determine the capacitor voltage at other times after the switch is closed Any of the five variables can be determined by supplying the other four For example in the graph below a 1 Farad capacitor charging through a 1 ohm resistor and 1 volt battery will reach 777 millivolts in 1 5 seconds From left to right the entries would be 1 001 1000000 1500 with the Instantaneous Voltage field

    Original URL path: http://bowdenshobbycircuits.info/rc.htm (2016-04-26)
    Open archived version from archive

  • RL Time Calculator
    in 1 second of time which is the ratio of inductance to resistance L R 1 second The maximum value of current is determined from ohms law or I E R 1 volt 1 Ohm 1 amp The calculator below can be used to determine various other points along the graph or the inductance and resistance needed for other situations Four known values must be entered to solve for the

    Original URL path: http://bowdenshobbycircuits.info/rl.htm (2016-04-26)
    Open archived version from archive

  • LED Series Resistor Calculator
    LEDs the individual LED voltage 1 6 to 4 5 the desired current normally 10 to 20 mA and the total supply voltage 3 6 9 12 etc Press find resistance to find the resistor value needed Use a resistor rated higher than the displayed power in the box below Series Resistor most cases can use a 1 4 watt resistor Several common LED connections are shown in the drawing

    Original URL path: http://bowdenshobbycircuits.info/led.htm (2016-04-26)
    Open archived version from archive

  • Gregorian Calendar
    every 4 years Under the new rules leap years now occur when the year is divisible by 4 and not 100 or the year is divisible by 400 Thus the years 1600 and 2000 are leap years but 1700 1800 1900 and 2100 are not Under this system the calendar should be accurate within a day for about 3322 years To use the calendar below select a month from the

    Original URL path: http://bowdenshobbycircuits.info/Calendar.htm (2016-04-26)
    Open archived version from archive


  • take a few pieces out and chop them up and mix with chopped green oinions and ginger or whatever other stuff and spices you like Then take out a wonton wrapper and put some of the mixture in the middle Then wet the edges of the wrapper with water so it s soft and fold the wrapper over from one corner to the other so it makes a triangle Then take a little more water on your finger and rub the wonton edges to seal the wrappers Then make another 5 or 6 wonton wraps and fry them all in a pan for a few seconds A few seconds on one side and a few seconds on the other just so they are slightly brown and won t fall apart Might have to add a little oil to the pan so they don t stick Next go back to cooking the chicken and add more water as it cooks so you get a broth with chicken pieces that s enough for the soup I use about 5 cups of water and one chicken thigh with the fat cut off While the chicken is slowly cooking low heat you can chop

    Original URL path: http://bowdenshobbycircuits.info/recipes.htm (2016-04-26)
    Open archived version from archive

  • Electronic Components For Sale.
    0 05 4 7 uF 35 Volt 0 05 10 uF 50 Volt 0 05 22 uF 16 Volt 0 05 33 uF 25 Volt 0 05 47 uF 16 Volt 0 05 100 uF 50 Volt 0 10 220 uF 35 Volt 0 10 330 uF 35 Volt 0 10 470 uF 16 Volt 0 10 1000 uF 25 Volt 0 15 2200 uF 10 Volt 0 15 2200 uF 16 Volt 0 25 2200 uF 35 Volt 0 50 3300 uF 25 Volt 0 50 4700 uF 25 Volt 0 75 4700 uF 50 Volt 1 00 4700 uF 80 Volt 2 00 500 000 uF 5 Volt 0 50 120 VAC Wall Transformers 1 each 4 5 DC 600mA 6 3 AC 2 Amp 6 9 DC 2 VA 8 AC 100mA 9 DC 1 Amp 2 12 AC 2 4VA Dual Secondary 2 at 12VAC 12 AC 830mA or 14 VAC 500mA 12 DC 830mA 14 DC 700mA 20 AC 500mA 20 5AC 330mA 21 7AC 6 6VA 24 AC 250mA 25 DC 4 5VA 25 2 18 3 AC 10VA 3 terminal output Transistors 2N4123 NPN 30V 200mA hfe 50 at 2 mA 0 01 These 2N4123s have mangled leads from a processing machine Most of the leads are broken at 3 16 inch length A good substitute for 2N3904 About 2000 available Each 2SC1815 NPN 70 Volt 400mA HFE 120 0 10 2SC3886A NPN 1500 Volt 8 Amps HFE 8 3 00 2SC4744 NPN 1500 Volt 6 Amps HFE 2 00 2SA1015Y PNP 100 Volt 500mA HFE 100 0 10 BF370 NPN 100mA HFE 77 0 10 2SC2682 NPN 180 Volt 1 5 Amp HFE 100 0 25 2SB668 PNP 160 Volt 12 Amps HFE 60 1 00 2SD718 NPN 160 Volt 12 Amps

    Original URL path: http://bowdenshobbycircuits.info/sale.htm (2016-04-26)
    Open archived version from archive